Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 378

JUNOSe 11.1.x Link Layer Configuration Guide
show ppp interface summary
346
Monitoring MLPPP
IPCP protocol status
operational-status
IPCP negotiated options
ip-address
ip-address-mask
primary-dns-address
secondary-dns-address
primary-wins-address
secondary-wins-address
IPV6CP protocol configuration
configured
...
PPP multilink member-interface ATM 0/0.10 is up
Link interface administrative status is open
Link interface fragmentation is enabled
Link interface fragment size is (use MTU)
Link interface reassembly is enabled
Link interface administrative MRRU is (use MRU)
Link interface hash-link-selection is disabled
No baseline has been set
...
Authentication status
grant
session-timeout
inactivity-timeout
monitor-ingress-only
accounting-timeout
peer-ip-address
peer-ip-address-mask
peer-primary-dns-address
peer-secondary-dns-address
peer-primary-wins-address
peer-secondary-wins-address
peer-ipv6-interface-id
See show ppp interface.
Use to display a summary of all the multilinked and nonmultilinked PPP interfaces
configured on the router.
Field descriptions
PPP Status Non-multilinked PPP interfaces
Configuration status Indicates the configuration state of the PPP interface,
IPCP, IPv6CP , OSINLCP, or MPLS
configured Interface or protocol is configured
notConfigured Interface or protocol is not configured
Administrative status Indicates the administrative state of the PPP interface,
IPCP, IPv6CP , OSINLCP, or MPLS
open Interface or protocol is administratively enabled
closed Interface or protocol is administratively disabled
up
local peer
192.168.1.1 100.100.100.17
none none
none none
none none
none none
none none
true
true
31622400 seconds
none
false
none
100.100.100.17
none
none
none
none
none
none