Table of Contents
Advertisement
Configuring Fragmentation on Multiclass MLPPP Interfaces
You can configure fragmentation on a multiclass MLPPP interface with the same
fragment size as that of the MLPPP interface.
Before you configure fragmentation on the multiclass MLPPP interface:
To configure fragmentation on a multiclass MLPPP interface:
NOTE: You must include the best-effort traffic class in the ppp multilink multiclass
fragmentation command, or the command fails.
Related Topics
Configuring Reassembly on Multiclass MLPPP Interfaces
You can configure reassembly on a multiclass MLPPP interface with the same
maximum received reconstructed unit (MRRU) value as that of the MLPPP interface.
Before you configure reassembly on the multiclass MLPPP interface:
To configure reassembly on a multiclass MLPPP interface:
Ensure that fragmentation is enabled on the MLPPP interface.
See Configuring MLPPP Fragmentation and Reassembly in JUNOSe Link Layer
Configuration Guide, Chapter 8, Configuring Multilink PPP.
Specify the QoS traffic classes to be fragmented.
To configure fragmentation on multilink classes in a dynamic profile:
host1(config-profile)#ppp multilink multiclass fragmentation best-effort voice
otherData video
To configure fragmentation on multilink classes in a static MLPPP interface:
host1(config-if)#ppp multilink multiclass fragmentation best-effort voice
otherData video
The order of the QoS traffic classes does not affect the execution of the command.
JUNOSe Link Layer Configuration Guide, Chapter 17, Configuring Dynamic Interfaces
ppp multilink multiclass fragmentation
Ensure that reassembly is enabled on the MLPPP interface.
See Configuring MLPPP Fragmentation and Reassembly in JUNOSe Link Layer
Configuration Guide, Chapter 8, Configuring Multilink PPP.
Specify the QoS traffic classes to be reassembled.
Configuring Fragmentation on Multiclass MLPPP Interfaces
Chapter 10: Configuring Multiclass Multilink PPP
355
Advertisement
Table of Contents
Troubleshooting
