Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 184

JUNOSe 11.1.x Link Layer Configuration Guide
show frame-relay summary
152
Monitoring MLFR
In bytes: 512
In frames: 16
In errors: 0
In discards: 16
In unknown protos: 0
Frame relay sub-interface mlframe-relayTEST.2, status is up
Number of sub-interface down transitions is 0
Time since last status change 00:07:50
In bytes: 512
In frames: 16
In errors: 0
In discards: 16
In unknown protos: 0
See show frame-relay subinterface.
Use to scan all defined Frame Relay interfaces and circuits and to report the
status for each discovered interface and circuit as follows:
Up—Traffic can flow on the interface
Down—Traffic cannot flow because of a problem in the network
Unavailable Traffic cannot flow because hardware is unavailable
Example
host1#show frame-relay summary
2 multilink interface(s) defined, 2 up, 0 down
1 interface(s) defined, 1 up, 0 down
2 sub-interface(s) defined, 2 up, 0 down
2 circuit(s) defined, 2 up, 0 down
See show frame-relay summary.
Out bytes: 0
Out frames: 0
Out errors: 0
Out discards: 0
Out bytes: 0
Out frames: 0
Out errors: 0
Out discards: 0