Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 743

Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
option 82 field of DHCP messages or in the DSL Forum VSA 26-1 of PPPoE PADR
and PADI packets. Using this keyword causes the router to display the
agent-circuit-identifier string in the command output.
Field descriptions
Interface Type and specifier of the VLAN subinterface
Status Status of the VLAN subinterface: up, down, dormant,
lowerLayerDown, absent
MTU Maximum allowable size (in bytes) of the MTU for the VLAN
subinterface
Svlan Id S-VLAN ID value, if configured
Vlan Id VLAN ID value for the VLAN subinterface
Ethertype S-VLAN Ethertype value, if configured
Type Type of VLAN subinterface
Static VLAN or S-VLAN subinterface was configured statically
Dynamic VLAN or S-VLAN subinterface was configured dynamically
Auto configure interface(s) Types of dynamic upper interfaces configured
with the auto-configure command: IP or PPPoE
Detected dynamic interface Type of dynamic upper interface detected
during autoconfiguration: IP, PPPoE, or (if no packet has been received)
none
Interface types in lockout Encapsulation types currently experiencing
lockout: IP, PPPoE, or none
Lockout state (seconds) Settings of encapsulation type lockout for the
upper-layer encapsulation type indicated
Min Minimum lockout time, in seconds
Max Maximum lockout time, in seconds
Current Current lockout time, in seconds; displays 0 (zero) if lockout
is not occurring
Elapsed Time elapsed into the lockout time, in seconds; displays 0
(zero) if lockout is not occurring
Next Lockout time for the router to use for the next lockout event, in
seconds
In Analysis of inbound traffic on this interface
Bytes Number of bytes received on the VLAN or S-VLAN subinterface
Packets Sum of all unicast, broadcast, and multicast packets received
on the VLAN or S-VLAN subinterface
Monitoring Dynamic Interfaces and Profiles
711