Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 652

JUNOSe 11.1.x Link Layer Configuration Guide
2.
NOTE: The router prompts you for a password only if you have configured a password
to control access to Privileged Exec mode. For details about setting passwords to
access various command privilege levels, see chapter Passwords and Security in
JUNOSe System Basics Configuration Guide.
3.
NOTE: Issuing the profile-reassign command causes the router to tear down any
dynamic interfaces that exist above the ATM 1483 subinterface. After the profile is
reassigned, the router restores the interfaces based on the necessary client
reconnections. If the ATM 1483 subinterface is currently shut down, issuing the
profile-reassign command does not reestablish the interface connection.
4.
5.
enable
620
Troubleshooting PPP and PPPoE Dynamic Interfaces
system maximums, see JUNOSe Release Notes, Appendix A, System
Maximums.
For details about creating and using profiles, see "Configuring a Dynamic Interface
from a Profile" on page 563.
Access Privileged Exec mode at privilege level 5 or higher.
host1>enable 5
Password: *********
host1#
From Privileged Exec mode, issue the profile-reassign command to replace the
nondebug profile currently assigned to the specified encapsulation type for the
specified ATM 1483 interface with the debug profile created in Step 1.
You must specify one of the following encapsulation types to which the debug
profile applies: ppp, pppoe, or any. You can use the any encapsulation type if
neither the ppp encapsulation type nor the pppoe encapsulation type has an
existing profile assignment. For example:
host1#profile-reassign atm 2/0.101 ppp pppLogConfig
(Optional) Use the appropriate show command to verify the profile reassignment.
For example:
host1#show atm subinterface atm 2/0.101
When you reassign a debug profile to an ATM 1483 subinterface, the
reassignment is stored in NVS and persists after a reboot. If you issue the show
atm subinterface or show configuration command after the profile is reassigned,
these commands display the new profile assignment.
(Optional) To restore the initial (nondebug) profile assignment after you
troubleshoot the dynamic interface, issue the profile-reassign command again
using the name of the nondebug profile. For example:
host1#profile-reassign atm 2/0.101 ppp pppConfig