Module Requirements; Interface Specifiers; Multiclass Mlppp References; Configuring Multiclass Mlppp - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide

Module Requirements

For information about modules that support multiclass MLPPP on the E120 and E320
Broadband Services Routers:

Interface Specifiers

For E120 and E320 routers, use the slot/adapter/port format, which includes an
identifier for the bay in which the I/O adapter (IOA) resides. In the software, adapter
0 identifies the right IOA bay (E120 router) and the upper IOA bay (E320 router);
adapter 1 identifies the left IOA bay (E120 router) and the lower IOA bay (E320
router). For example, the following command specifies a gigabitEthernet interface
on slot 3, adapter 0, port 0 of an E320 router.
Related Topics

Multiclass MLPPP References

For more information about multiclass MLPPP, see the following resources:
Related Topics

Configuring Multiclass MLPPP

When you configure multiclass MLPPP, you enable the creation of multilink classes
on the MLPPP interface and assign QoS traffic classes to the multilink classes. You
352
Multiclass MLPPP References
E120 router
E320 router
See E120 and E320 Module Guide, Table 1, Module and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support multiclass MLPPP.
host1(config)#interface gigabitEthernet 3/0/0
Configuring Multiclass MLPPP on page 352
Interface Types and Specifiers in JUNOSe Command Reference Guide
Multiclass MLPPP Overview on page 349
RFC 1990 The PPP Multilink Protocol (MP) (August 1996)
RFC 2686 The Multi-Class Extension to Multi-Link PPP (September 1999)
Configuring Multiclass MLPPP on page 352
Multiclass MLPPP Overview on page 349