Monitoring Dynamic Interfaces And Profiles - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

vlan bulk-config

Monitoring Dynamic Interfaces and Profiles

You can use the show commands described in this section to monitor configurations
created with dynamic interfaces and profiles.
NOTE: The E120 and E320 routers output for monitor and show commands is
identical to output from other E Series routers, except that the E120 and E320 routers
output also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
show atm aal5 interface
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
You must specify an interface location, which is the identifier of another interface
on which the router has an assigned IP address. This interface cannot be another
unnumbered interface.
Examples
host1(config-if)#ip unnumbered fastEthernet 3/0
host1(config-if)#ip unnumbered loopback 10
Use the no version to disable IP processing on the interface.
See ip unnumbered.
Use to create a bulk-configured VLAN range on a static VLAN major interface for
use by a dynamic VLAN subinterface.
For detailed information about how to use this command, see "vlan bulk-config"
on page 677.
Example
host1(config)#vlan bulk-config test1 svlan-range 200 250 2 2
Use the no version to remove the specified VLAN range from the VLAN major
interface, to remove the specified subranges from the specified VLAN range, or
to remove all subranges from the specified VLAN range. The no version also
removes any overriding profile assignments for VLAN IDs or S-VLAN IDs within
the deleted VLAN range or VLAN subrange.
See vlan bulk-config/
Use to display information about a configured ATM AAL5 interface.
Field descriptions
AAL5 Interface operational status Operational status of the AAL5 interface:
up, down, lowerLayerDown
time since last status change Time since last reported change to the AAL5
interface operational status in hh:mm:ss format
Monitoring Dynamic Interfaces and Profiles
689