Configuring Pads Packet Content - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
pppoe service-name-table
profile

Configuring PADS Packet Content

By default, an E Series router acting as an AC sends both the AC-Name and AC-Cookie
tags as part of the PADS packet when it confirms a session with a PPPoE client. These
tags are defined in RFC 2516 as follows:
If necessary for compatibility with your network equipment, you can issue the pppoe
pads disable-ac-info command to prevent the router from sending the AC-Name
and AC-Cookie tags in the PADS packet.
pppoe pads disable-ac-info
412
Configuring PADS Packet Content
host1(config)#interface atm 3/0.1
host1(config)#interface atm 3/0/0.1
Use the no version to remove the interface or subinterface.
See interface atm.
Use from Profile Configuration mode to assign a PPPoE service name table to a
profile for use by the dynamic PPPoE interface column associated with the profile.
Specify the name of the PPPoE service name table configured with the
pppoe-service-name-table command from Global Configuration mode.
Example
host1(config-profile)#pppoe service-name-table myServiceTable1
Use the no version to remove the PPPoE service name table assignment.
See pppoe service-name-table.
Use from Global Configuration mode to create a profile name of up to 80
characters.
Use from Subinterface Configuration mode to assign a profile to an interface.
Specify pppoe as the encapsulation type to which the profile applies.
Examples
host1(config)#profile myProfile
host1(config-subif)#profile pppoe myProfile
Use the no version to remove a profile (from Global Configuration mode) or to
remove the profile assignment (from Subinterface Configuration mode).
See profile.
AC-Name String that uniquely identifies the particular AC
AC-Cookie Tag used by the AC to help protect against denial of service (DoS)
attacks