Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 60

JUNOSe 11.1.x Link Layer Configuration Guide
atm atm1483 snmp trap link-status
atm auto-configuration
atm cac
atm clock internal
28
Setting Optional Parameters
Use the no version to enable a disabled subinterface.
See atm atm1483 shutdown.
Use to enable SNMP link status traps on an ATM 1483 layer subinterface.
Example
host1(config-subif)#atm atm1483 snmp trap link-status
Use the no version to disable the traps.
See atm atm1483 snmp trap link-status.
Use to enable autoconfiguration of ILMI. Entering the atm auto-configuration
command overrides any previous configuration of the atm uni-version command.
Autoconfiguration is enabled by default.
Example
host1(config-if)#atm auto-configuration
Use the no version to disable autoconfiguration and set the ILMI parameters to
the UNI version configured using the atm uni-version command, which has a
default value of UNI 4.0.
See atm auto-configuration.
Use to enable CAC on the interface. You can set a subscription limit, so you can
oversubscribe the port, and the UBR weight, so you can limit the number of UBR
connections.
You cannot configure CAC on an ATM interface on which you have created a
bulk-configured VC range for use by a dynamic ATM 1483 subinterface.
Conversely, you cannot create a bulk-configured VC range on an ATM interface
on which you have configured CAC. For information about creating
bulk-configured VC ranges, see "Bulk Configuration of VC Ranges" on page 631
in "Configuring Dynamic Interfaces Using Bulk Configuration" on page 623.
Example
host1(config-if)#atm cac 3000000 ubr 3000
Use the no version to disable CAC on the interface.
See atm cac.
Use to cause the ATM interface to generate the transmit clock internally.
You must specify one of the following: