Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 423

ip address
pppoe acName
pppoe duplicate-protection
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
port Port number on the IOA
subinterface Number of the subinterface in the range 1–2147483647
For more information, see "Creating a Basic Configuration" on page 22 in
"Configuring ATM" on page 3.
Examples
host1(config)#interface atm 0/1.19
host1(config)#interface atm 0/0/1.19
Use the no version to remove the interface or subinterface.
See interface atm.
Use to assign an IP address and subnet mask to a subinterface.
Example
host1(config-if)#ip address 192.1.1.1 255.255.255.0
Use the no version to remove an IP address or disable IP processing.
See ip address.
Use to configure an access concentrator (AC) name on the PPPoE interface. When
the AC (the server) receives a PPPoE Active Discovery Initiation (PADI) packet
that it can serve, it replies by sending a PPPoE Active Discovery Offer (PADO)
packet. The PADO packet contains the AC name configured using this command.
If the AC name is not configured, the router name is used.
The AC name can be a maximum of 64 characters.
Example
host1(config-subif)#pppoe acName CYM9876
Use the no version to remove the AC name.
See pppoe acName.
Use to prevent a client from establishing more than one session using the same
MAC address.
This feature is disabled by default.
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
Configuring PPPoE over ATM
391