Configuring Dynamic Pppoe Over Static Pppoe With Ethernet And Vlan Interface Columns; Figure 48: Dynamic Pppoe Over Static Pppoe With Non-Vlan Interface - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
Figure 48: Dynamic PPPoE over Static PPPoE with Non-VLAN Interface Columns
To configure an Ethernet interface without VLANs to support a dynamic PPPoE
subinterface:
1.
2.
3.
4.
5.

Configuring Dynamic PPPoE over Static PPPoE with Ethernet and VLAN Interface Columns

Figure 49 on page 537 shows dynamic PPPoE subinterface columns and illustrates
an alternative method for PPPoE to support multiple IP sessions over each VLAN.
536
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interface.
host1(config)#interface fastEthernet 4/1
Assign an IP address and mask.
host1(config-if)#ip address 192.6.129.5 255.255.255.0
Specify PPPoE as the encapsulation method on the interface.
host1(config-subif)#encapsulation pppoe
This command creates the static PPPoE major interface.
Assign a profile to the PPPoE major interface.
host1(config-subif)#pppoe profile pppoeProfile3
Configure the interface to detect and accept dynamic PPPoE subinterfaces.
host1(config-subif)#pppoe auto-configure