Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 182

JUNOSe 11.1.x Link Layer Configuration Guide
show frame-relay subinterface
150
Monitoring MLFR
Out DE pkts Number of packets transmitted with the DE bit set
Dropped packets Number of dropped packets
Example 1
host1#show frame-relay pvc brief
PVC information for frame relay DTE interface mlframe-relayTEST
DLCI 16 in sub-interface mlframe-relayTEST.1, status is active
DLCI 17 in sub-interface mlframe-relayTEST.2, status is active
Example 2
host1#show frame-relay pvc interface mlframe-relay TEST
PVC information for frame relay DTE interface mlframe-relayTEST
DLCI 16 in sub-interface mlframe-relayTEST.1, status is active
Number of circuit status inactive transitions is 0
Time since creation 00:07:20, last status change 00:07:11
In pkts: 14
In bytes: 420
In FECN pkts: 0
In BECN pkts: 0
In DE pkts: 0
Dropped pkts: 14
DLCI 17 in sub-interface mlframe-relayTEST.2, status is active
Number of circuit status inactive transitions is 0
Time since creation 00:07:20, last status change 00:07:11
In pkts: 14
In bytes: 420
In FECN pkts: 0
In BECN pkts: 0
In DE pkts: 0
Dropped pkts: 14
See show frame-relay pvc.
Use to display the state of the subinterface.
The subinterface can be in one of the following states:
Up—Traffic can flow on the interface
Offline—Traffic cannot flow because hardware is unavailable
Down—Traffic cannot flow because of a problem in the interface at the
current protocol layer
LowerLayerDown—Traffic cannot flow because of a problem in an interface
at a lower protocol layer
AdministrativelyDown—Traffic cannot flow because of manual administrative
intervention
Use the brief keyword to display only the operational status of all configured
subinterfaces.
Out pkts: 0
Out bytes: 0
Out FECN pkts: 0
Out BECN pkts: 0
Out DE pkts: 0
Out pkts: 0
Out bytes: 0
Out FECN pkts: 0
Out BECN pkts: 0
Out DE pkts: 0