Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 674

JUNOSe 11.1.x Link Layer Configuration Guide
atm bulk-config
NOTE: For information about the maximum number of ATM 1483 bulk configurations
supported per chassis, see JUNOSe Release Notes, Appendix A, System Maximums.
NOTE: For information about the maximum number of VCs (sum of the VPI/VCI
addresses within all VC subranges) that you can configure with the atm bulk-config
command per line module and per chassis, see JUNOSe Release Notes, Appendix A,
System Maximums.
Do not use any reserved VCI values when configuring VCs with the atm bulk-config
command. For information about reserved VCIs, see "Configuring F4 OAM" on
page 33 in "Configuring ATM" on page 3.
642
Configuring ATM 1483 Dynamic Subinterfaces
Example 1
host1(config-profile)#atm atm1483 subscriber ip user-prefix boston01
domain myisp password-prefix abc123
Example 2
host1(config-subif)#atm atm1483 subscriber bridgedEthernet user westford003
domain acmecorp.east password xyz123
Use the no version to remove the subscriber.
See atm atm1483 subscriber.
Use to create a bulk-configured VC range on a static ATM AAL5 interface for use
by a dynamic ATM 1483 subinterface.
Each VC range consists of one or more nonoverlapping VC subranges. A VC
subrange is a group of VCs that resides within the VPI and VCI ranges you specify.
You can configure multiple VC ranges on an ATM AAL5 interface.
When you create a bulk-configured VC range, you must specify the following:
A name of up to 80 alphanumeric characters; this is also referred to as the
bulk configuration name
The starting and ending VPI values (inclusive) for each VC subrange
The starting and ending VCI values (inclusive) for each VC subrange
You can create a placeholder VC range by issuing the atm bulk-config command
without specifying any subranges. You can assign a profile to this placeholder
and add subranges to it later.
You can add and remove individual VC subranges.
You cannot remove a VC subrange if any dynamic ATM 1483 subinterfaces
currently exist for any circuit within the subrange. Use "atm bulk-config