Working With Profiles; Figure 54: Creating And Configuring A Profile - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide

Working with Profiles

Figure 54 on page 568 shows how to create a profile and assign characteristics to it.

Figure 54: Creating and Configuring a Profile

Figure 55 on page 569 shows how to assign a profile to static interfaces. These static
interfaces create dynamic interfaces above them.
568
Configuring a Dynamic Interface from a Profile
advisory-rx-speed Sets an advisory receive speed for VLAN subinterfaces
advisory-tx-speed Sets an advisory connect speed for VLAN subinterfaces
auto-configure Specifies the types of upper-interface encapsulations that are
accepted or detected by the dynamic VLAN subinterface
auto-configure agent-circuit-identifier Enables the creation of VLAN subinterfaces
that are based on agent-circuit-identifier information
description Assigns a description to VLAN subinterfaces that are created with
this profile
policy Attaches (or removes) a policy to (or from) a dynamically created VLAN
profile Adds a nested profile assignment, which references another profile that
dynamically configures an upper-interface encapsulation type over the VLAN
subinterface
service-profile Specifies a service profile name to a dynamically created VLAN
svlan ethertype Specifies that the packet must use this Ethertype to create the
dynamic VLAN subinterface