Configuring Pppoe Over A Static Ethernet Interface; Figure 9: Example Of Ip Over Ethernet Stacking Configuration Procedure - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
2.
Figure 9 on page 156 illustrates this configuration.

Figure 9: Example of IP over Ethernet Stacking Configuration Procedure

Configuring PPPoE over a Static Ethernet Interface

To configure PPPoE over an Ethernet interface:
1.
2.
3.
4.
5.
6.
Figure 10 on page 157 illustrates this configuration.
156

Configuring PPPoE over a Static Ethernet Interface

Create an IP interface.
host1(config-if)#ip address 192.5.127.8 255.255.255.0
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet port.
host1(config)#interface fastEthernet 4/1
Specify PPPoE as the encapsulation method on the interface.
host1(config-if)#pppoe
Create a PPPoE subinterface.
host1(config-if)#pppoe subinterface fastEthernet 4/1.1
Specify PPP as the encapsulation method on the interface.
host1(config-if)#encapsulation ppp
Assign an IP address and mask.
host1(config-if)#ip address 164.10.6.51 255.255.255.0
(Optional) Configure additional PPPoE subinterfaces by completing Steps 3
through 5 using unique numbering.