Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 24

JUNOSe 11.1.x Link Layer Configuration Guide
Chapter 7
Chapter 8
Chapter 9
Chapter 12
Chapter 14
Chapter 15
Chapter 17
Chapter 18
xxiv
List of Figures
Figure 27: GE-8 IOA Configuration Across IOAs (1:N) ..................................215
Figure 28: Dual-Homed Configuration (1:1) .................................................215
Figure 29: Dual-Homed Heterogeneous Configuration in an RSTP
Network ................................................................................................219
Configuring IEEE 802.3ah OAM Link-Fault Management
Figure 30: OAM PDU Format .......................................................................230
Figure 31: OAM Sublayer Interfaces ............................................................232
Figure 32: OAM Sublayer Entities ................................................................233
Figure 33: Interrelationship Between 802.3ah OAM and 802.3ad LAG ........241
Configuring Point-to-Point Protocol
Figure 34: Authentication with EAP .............................................................267
Configuring Multilink PPP
Figure 35: MLPPP Aggregation of T1 Lines into a Single Bundle ..................304
Figure 36: Structure of MLPPP .....................................................................304
Configuring Point-to-Point Protocol over Ethernet
Figure 37: PPPoE over ATM .........................................................................376
Figure 38: Example of PPPoE over ATM Stacking ........................................389
Figure 39: Example of Configuring IPv4 and IPv6 over PPPoE ....................394
Figure 40: Example of PPPoE Stacking ........................................................398
Configuring Bridged Ethernet
Figure 41: Bridged Ethernet Topology, Router Terminating and Routing
Traffic ...................................................................................................444
Figure 42: Interface Stacking for VLANs over Bridged Ethernet ...................445
Configuring Transparent Bridging
Figure 43: Bridge Group with Fast Ethernet and Gigabit Ethernet Bridge
Interfaces ..............................................................................................469
Configuring Dynamic Interfaces
Figure 44: Configuring an ATM 1483 Interface to Support Dynamic
Interfaces ..............................................................................................522
Figure 45: Dynamic PPP Interface Columns ................................................529
Figure 46: Dynamic PPPoE Interface Columns ............................................529
Figure 47: Dynamic PPPoE over Static PPPoE with ATM Interface
Columns ...............................................................................................534
Figure 48: Dynamic PPPoE over Static PPPoE with Non-VLAN Interface
Columns ...............................................................................................536
Figure 49: Dynamic PPPoE over Static PPPoE with VLAN Interface
Columns ...............................................................................................537
Figure 50: IPv4 and IPv6 Interface Columns over Static and Dynamic
PPPoE ...................................................................................................538
Figure 51: Dynamic PPPoE over Static PPPoE with S-VLAN Interface
Columns ...............................................................................................543
Figure 52: Dynamic IPoA over Static ATM 1483 Interface Columns ............553
Figure 53: Dynamic Bridged Ethernet over Static ATM 1483 Interface
Columns ...............................................................................................558
Figure 54: Creating and Configuring a Profile ..............................................568
Figure 55: Assigning a Profile to a Static Interface .......................................569
Configuring Dynamic Interfaces Using Bulk Configuration
227
263
303
375
443
467
515
623