Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 673

atm atm1483 subscriber
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
Example
host1(config-profile)#atm atm1483 profile pppoe atm1483ProfilePppoe
Use the no version to remove the profile assignment for the upper-interface
encapsulation type.
See atm atm1483 profile.
Use to configure a local subscriber for a dynamic upper-interface encapsulation
type configured over a dynamic ATM 1483 subinterface. A subscriber supports
authentication and configuration from the RADIUS server.
Optionally, you can include this command in the base profile for a dynamic ATM
1483 subinterface.
When you configure a subscriber, you must specify the following:
upperInterfaceType Type of dynamic interface, bridgedEthernet or ip
userNameUsage How the dynamic interface uses the username for
authentication purposes
user Use the name as specified.
user-prefix Use the name as a prefix to the interface physical location.
The router automatically postpends the physical location of the user to
the username string. The username format is userName.slot.port.vpi.vci.
The resulting username string is then used to authenticate the subscriber
with the RADIUS server.
userName RADIUS username
domainName Domain name
You can optionally supply password information:
passwordUsage How the dynamic interface uses the password for
authentication purposes
password Use the password as specified.
password-prefix Use the password as a prefix to the interface physical
location. The router automatically postpends the physical location of the
user to the password string. The password format is
password.slot.port.vpi.vci. The resulting password string is then used to
authenticate the subscriber with the RADIUS server.
password RADIUS password
If your router is running stateful SRP switchover (high availability), the use of
the atm atm1483 subscriber command to configure RADIUS authentication for
subscribers on dynamic bridged Ethernet interfaces might suspend stateful SRP
switchover on the router or prevent stateful SRP switchover from becoming
active. For more information about using the subscriber management application
to bypass this limitation, see "Authenticating Subscribers on Dynamic Bridged
Ethernet over Dynamic ATM Interfaces" on page 636.
Configuring ATM 1483 Dynamic Subinterfaces
641