Monitoring Shared Shaper Algorithm Variables; Table 42: Show Qos Shared-Shaper-Control Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual

JunosE 11.3.x Quality of Service Configuration Guide
Related
Documentation

Monitoring Shared Shaper Algorithm Variables

Purpose
Action
Meaning
312
Table 41: show qos shared-shaper Output Fields (continued)
Field Name
Total constituents
Total number of shared shapers
that are disabled (in failover
mode) due to lack of resources
Compound shared shapers are
[not] supported
Configuring a Scheduler Hierarchy on page 47
Configuring Simple Shared Shaping on page 77
Configuring Compound Shared Shaping on page 96
Configuring Interface Sets for QoS on page 201
Configuring Interface Supersets for QoS on page 200
show qos shared-shaper
Display information about the user-configurable variables for controlling the simple
shared shaper algorithm.
To display information about all variables:
host1#show qos-shared-shaper-control
control
control name
-------------------- -------
maximum voql
reaction factor
convergence factor
minimum dynamic rate
Table 42 on page 312 lists the show qos shared-shaper-control command output fields.

Table 42: show qos shared-shaper-control Output Fields

Field Name
control name
control value
units
Field Description
Total number of resource constituents for all shared
shapers
Total number of shared shapers that are disabled (in
failover mode) due to lack of resources
Indication of whether compound shared shapers are
supported; determined by installed hardware
value units
---------------
400 milliseconds
75 percent
50 percent
0 percent
Field Description
Name of the simple shared shaper control
Value of the simple shared shaper control; default
values are displayed if none specified
Expressed units for the value of the simple shared
shaper control
Copyright © 2010, Juniper Networks, Inc.