Services
Ethernet network bonding
The TX54 device supports bonding mode for the Ethernet network. This allows you to configure the
device so that Ethernet ports share one IP address. When both ports are being used, they act as one
Ethernet network port.
Required configuration items
Enable Ethernet bonding.
n
The mode, either:
n
Active-backup. Provides fault tolerance.
l
Round-robin. Provides load balancing as well as fault tolerance.
l
The Ethernet devices in the bonded pool.
n
WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Ethernet bonding.
4. For Add Bond device, click
The bond device is enabled by default. To disable, click to toggle off Enable.
TX54 User Guide
Ethernet network bonding
606