Table of Contents
Advertisement
Services
(config service multicast test)> src_interface
b. Set the interface. For example:
(config service multicast test)> src_interface /network/interface/eth1
(config service multicast test)>
8. Set a destination interface that the IX20 device will send mutlicast packets to:
a. Use the ? to determine available interfaces:
(config service multicast test)> src_interface ?
Destination interface: Which interface to send the multicast packets.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config service multicast test)> src_interface
b. Set the interface. For example:
(config service multicast test)> add interface end
/network/interface/eth1
(config service multicast test)>
c. Repeat for each additional destination interface.
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Ethernet network bonding
The IX20 device supports bonding mode for the Ethernet network. This allows you to configure the
device so that Ethernet ports share one IP address. When both ports are being used, they act as one
Ethernet network port.
IX20 User Guide
Ethernet network bonding
505
Advertisement
Table of Contents
