Recording Configuration - Keysight N9913A User Manual

RTSA (Real-Time Spectrum Analyzer) Mode—Option 350 (CPU2 Only)
Record/Playback (RTSA Option)
—

Recording Configuration

To change Recording Configuration settings:
— Press Trace 6
— Then
— Then
— Then
Then choose from the following:
—
—
230
— Playback State/Tag
tag, or scroll through the state tags. Enter a value between 1 and the
total number of state tags using the numeric keypad,
the rotary knob. Active when playback is paused. Learn more in
About State and User Tags in
page 227.
— Playback Trace
continue playback from a specific trace, or scroll through traces
manually. Enter a value between 1 and the total number of traces
using the numeric keypad,
Stop Immediately stops playback. Then choose from the following:
— Play Start playback from trace 1.
— Record Resume recording from the last recorded trace.
— Record Playback Setup
Configuration settings or Close the session.
Record Playback
New Session or
Recording Configuration
Record Time Sets the amount of time to record traces. Default is MAX,
which is to record indefinitely. Enter a value between 1s and 1 Ms (million)
seconds using the numeric keypad,
set, a timer appears during recording in the lower-left corner which counts
DOWN from the specified time.
Record Source Determines which trace is recorded. Sets where, in the
FieldFox data flow, data is recorded. Learn more in
page 231. Choose from the following:
— First Active Trace
active trace (1,2, 3 or 4) (i.e., any state other than View or Blank).
— Trace 1,2,3,4 Records data from the corresponding trace in its
current state.
Allows you to continue playback from a state
"About State and User Tags" on
Activated automatically when Paused. Allows you to
arrows, or the rotary knob.
Return to the setup menu to change
Recall an existing session.
arrows, or the rotary knob. When
(Default) This setting automatically selects the first
Keysight N9927-90001 User's Guide
arrows, or
"Record Source" on