Tcp/Ip Address Configuration; Address Setting In Local Control - Keysight M9290A Getting Started And Troubleshooting Manual

TCP/IP Address Configuration

CXA-m signal analyzer support the TCP/IP connection standards for LAN and
HiSLIP (High-Speed LAN Instrument Protocol) instruments.
In general, modern driver technology hides the details of the hardware connection
from the programmer, so your instrument's actual hardware connection is unlikely to
have any significant effect on the optimal choice of programming tool, language or
ADE.
There are two different connection configuration to control a CXA-m signal analyzer
in chassis.
Local Control - The controller is a modular installed in the chassis with CXA-m
signal analyzer or the controller is a PC and there is not any controller module
installed in chassis. Both of the two connections use the PCI-PCI bridge for data
communication.
Remote Control - The controller is a modular installed in the chassis and an external
PC controls the CXA-m signal analyzer via LAN connection as a remote controller.

Address Setting in Local Control

Please refer to the procedures below to set the TCP/IP address in local control.
1. Run LaunchModularSA.exe in controller. The pop-up window is shown as
2. Click Show Advanced Settings. For this analyzer, the "HiSLIP Dev" value is 4.
below.
This value will be used to set the remote name in Keysight Connection Expert.
Running Modular SA application
TCP/IP Address Configuration
65