Trigger Configuration Dialog Box - Keysight B2980B Series User Manual

Trigger Configuration Dialog Box

This dialog box is used to set the trigger parameters in detail. Note that the
overlapped parameter values are ignored and replaced with the settings made on
the Meter view. See
Layer
Action
Count
Bypass
Trigger Source
Period
Keysight B2980B User's Guide, Edition 1
"Trigger Setup Sub-panel" on page
Specifies the layer or device action set by this dialog box.
ARM: Arm layer
TRIGGER: Trigger layer
ACTION: Device action
For ACTION, the available parameters are Layer, Action, and
Trigger Output.
Specifies the device action type set by this dialog box.
TRANS.: (B2985B/B2987B) Transient (voltage source output)
device action
ACQ.: Acquire (measurement) device action
Count, 1 to 100000 or INF. (infinity), for the action specified by
the Layer and Action parameters
Bypass, ON or OFF
Bypass = ON enables the bypass only for the first passage to
the event detector for the action specified by the Layer and
Action parameters.
Bypass = OFF disables the bypass.
Event for the action specified by the Layer and Action
parameters. AUTO, BUS, TIMER, INT1, INT2, LAN, EXT1, EXT2,
EXT3, EXT4, EXT5, EXT6, EXT7, or TIN (Trigger In connector).
See Table 4-9.
For using the Trigger In connector, it is necessary to set input
trigger polarity. See "BNC Configuration Dialog Box" on
page 195.
Only for the TIMER event.
Interval of the TIMER event for the action specified by the Layer
and Action parameters, 10 s to 100000 s
Front Panel Reference
Trigger Key Group
157.
183