Manipulating Objects On The Build Tray; Positioning Objects On The Z-Axis - Stratasys Objet30 User Manual

Using Objet Studio

Manipulating Objects on the Build Tray

Positioning
Objects on the
Z-Axis
5–22
Avoid Support-Material Rule
This rule considers models that have large holes or hollows, open on at
least one side (like a pipe or a container).
It may be advantageous to print a model standing up, so support
material does not fill the hollow, even though printing the model lying
down would be much faster.
When you use the automatic positioning option to arrange objects on the
build tray (see "Automatic Orientation" on page 5‐18), the objects are
positioned directly on the tray. If you do not insert objects with automatic
positioning, they often appear either above or below the tray.
In practice, the Objet system prints all models on the build tray on a one-
millimeter bed of support material. The importance of positioning objects
directly on the build tray with Objet Studio is to correctly display the objects
on the screen.
To position objects directly on the tray:
1. Select the object.
2. From the Object menu, select
To ensure that objects are always positioned directly on the tray:
1. From the Tools menu, select
Figure 5-22: Options dialog box, Settings tab
2. In the Automatic Lay On (Gravity) section, select
Other Z-axis options (in the Automatic Lay On section):
•
When under the tray
tray is automatically changed so that the object is at tray level.
•
—The display of objects that are above or below the build tray is
Never
not changed.
.
Lay On
, and display the Settings tab.
Options
—The display of objects that are below the build
.
Always
DOC-24333 Rev. A