Table of Contents
Advertisement
Stratasys J850/J835 User Guide
5. Select the check box, and click Next.
6. Click Done in the final wizard screen.
Flushing the Print Block Pre-Heater
When the printer is configured to print in High Speed mode, or in Super High
Speed mode, the print-block pre-heater needs to be flushed periodically. This
is necessary to prevent possible clogging of unused material channels in these
modes. A message appears if 250 printing hours have passed since the print-
block pre-heater was flushed. The flushing process automatically switches
between the printing modes to flush all the channels and takes approximately
25 minutes.
• If you select to perform the automatic flushing when the message appears,
• If you postpone the automatic flushing, you can flush the pre-heater:
DOC-18001 Rev. N
Figure 4-146 Weight stabilization
the print job is printed automatically when the flushing is completed.
❒ when the next reminder appears at the beginning of a print job, as
described below.
❒ manually using the Material Replacement Wizard at a more convenient
time. See "Flushing the Print-Block Pre-Heater with the Material
Replacement Wizard" on page 4-98.
4 Operating and Maintaining the Printer
4-96
Advertisement
Table of Contents
