Z DRIVE BELT
Required Tools
•
3 mm hex wrench
•
Small flat head screwdriver
Removing the Z Drive Belt
1.
Power OFF the Printer. See
2.
Remove the rear top cover. See
3.
From inside the gantry enclosure, Use a 3 mm hex wrench to loosen the Z motor mounting
screws (4). See
Figure 7-31:
4.
Using a small flat head screwdriver, relax the belt tension by gently prying the Z motor tension
bracket away from the compression spring. See
Figure 7-32:
5.
While the belt tension is relaxed, remove the Z drive belt from its pulleys and extract it from the
printer.
"Powering Off" on page
"Removing the Rear Top Cover" on page
Figure
7-31.
Z Motor Mounting Screw Locations
Relaxing Z Belt Tension
169.
Figure
7-32.
189
174.