ADTRAN 1000R Series Command Reference Manual page 1036

Adtran network device manual
Hide thumbs Also See for 1000R Series:
Table of Contents

Advertisement

Command Reference Guide
switchport trunk native vlan <vlan id>
Use the switchport trunk native vlan command to set the VLAN native to the interface when the
interface is in trunking mode. To return to defaults, use the no version of this command.
Syntax Description
<vlan id>
Default Values
By default, this is set to VLAN 1.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1
Functional Notes
Configure which VLAN the interface uses as its native VLAN during trunking. Packets from this VLAN
leaving the interface will not be tagged with the VLAN number. Any untagged packets received by the
interface are considered a part of the native VLAN ID.
Usage Examples
The following example sets the native VLAN on port channel 1 to VLAN 2:
(config)#interface port-channel 1
(config-p-chan 1)#switchport trunk native vlan 2
61200510L1-35E
Specifies a valid VLAN interface ID (1 to 4094).
Command was introduced.
Copyright © 2005 ADTRAN
Port Channel Interface Config Command Set
1036

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 1000R Series and is the answer not in the manual?

Table of Contents

Save PDF