Configure The System Settings - Spectra Logic Spectra T950V User Manual

Chapter 4 — Configuring the Library

Configure the System Settings

The following table lists the system settings that are configured through
the Other Settings pane of the System Setup screen, describes how to
change each setting, and provides the default value for each setting, if
applicable.
Setting
Library Name
Web Server Port
Refresh Rate
August 2019
Description
Set the name used to identify the library in messages it
sends to mail recipients.
1. Type a name for the library. Use a name that helps
identify the library to a remote user.
2. Click Save.
Set the port number for the dedicated Ethernet port used to
access the library's embedded web server.
1. Enter a port number from 0 to 65,535.
The default port number is 80, which is appropriate for
most installations and is strongly recommended. If you
use a port number other than 80, the port number must
be explicitly entered into the web browser when
accessing the library remotely.
Important: Do not set the web server port to 443. Using
this port number causes the front panel display to
become unstable.
2. Click Save.
3. Reset the library to enable the new web port number
setting (see Resetting the Library on page 336).
Set how frequently the information on the BlueScale user
interface screens is refreshed.
1. Use the Refresh drop‐down list to select a scheduled
interval time.
2. Click Save.
Notes:
 You can manually refresh the displayed information at
any time by clicking the refresh display button located at
the left end of the status bar (see Status Bar on page 79).
 If you want to disable automatic refreshing of the display,
set the refresh rate to off.
 If you configure a setting other than the default refresh
rate or disable automatic refreshing, you must configure
the refresh rate every time you log into the library.
Configuring the Global System Settings
User Guide—Spectra T950V Library
Default
blank
(no name set)
80
60 seconds
101