Spectra Library Control Modules (Lcm And Rcm) - Spectra Logic Spectra T950V User Manual

Chapter 1 — Library Overview

Spectra Library Control Modules (LCM and RCM)

The library uses multiple Spectra LS control modules. These dedicated
computers run the library's BlueScale software, which controls and
manages all aspects of the library operation. Depending on where the
module is installed in the library, it functions as either the Library Control
Module (LCM) or the Robotics Control Module (RCM).
Spectra LS Components
shows the external components on the Spectra LS.
Figure 9 The connectors and components on the Spectra LS.
The following table describes the components shown in Figure 9.
Component
USB Ports
August 2019
 The main frame has both an LCM and an RCM; drive
Notes:
expansion frames only have an RCM.
 The LCM and the RCM in the main frame do not provide
failover redundancy for each other in the event that one of
the modules fails.
 Media expansion frames do not contain any library control
modules.
Note: When the control module is functioning as an RCM, the
connectors are only used for troubleshooting and diagnostic
purposes under the direction of Spectra Logic Technical Support.
Reset
USB ports (4)
Description
The USB ports on the LCM can be used to connect a USB device for transferring
BlueScale encryption keys, saving configurations, and uploading BlueScale
packages. You can also connect a USB keyboard and mouse to the USB ports on
the LCM and use them when interacting with the BlueScale user interface. This
connection provides access to all of the options available from the library's front
panel touch screen.
Note: Use the USB port(s) on the RCM to update the firmware on the RCM
during BlueScale package update or under the direction of Technical Support
for capturing motion traces that are used for troubleshooting.
SD memory card
(behind cover)
Monitor connector
Dedicated
Ethernet
EtherLib port
port
User Guide—Spectra T950V Library
Library Features
Fan
40