Calibrating The Touch Screen - Spectra Logic Spectra T950V User Manual

Chapter 14 — Maintaining the Library
9. Tighten the cord lock clamp screws (shown in Figure 236).
10. Repeat Step 7 through Step 9 for the other power cord.
11. Plug the free end of each power cord into an appropriate power source.
12. Repeat the entire process for the power cords attached to the dual AC
13. After cord locks are installed on all of the power cords, set the AC
C
ALIBRATING THE
If the touch points on the library's touch screen do not properly align with
the user interface graphics, perform the following procedure to recalibrate
the position of the touch points.
1. Log into the library as a user with superuser or administrator
2. From the toolbar menu, select Maintenance > Tools to display the
3. Select Utilities. The Utilities screen displays.
4. Select Calibrate Touch Screen.
5. Click Run Utility. The touch screen displays a series of calibration target
6. Touch each point as it displays with either the stylus or your finger to
7. When the calibration routine is complete, the Utilities screen
August 2019
module in each drive expansion frame.
breaker switches to the "on" position and power on the library.
T S
OUCH CREEN
Note: You must perform this procedure while standing in front of the
touch screen. The utility is not available when accessing the
library through the BlueScale web interface (RLC).
privileges.
Maintenance Tools screen (Figure 218 on page 393).
points.
recalibrate the touch points on the screen.
Note: Touch each point at a straight‐on angle as close to the center of
the target as possible.
redisplays.

Calibrating the Touch Screen

User Guide—Spectra T950V Library
413