Dding Or; Add A Drive To The Library - Spectra Logic Spectra T950V User Manual

Chapter 15 — Maintaining the Drives
A R

DDING OR

Only use drives obtained from Spectra Logic in the library. When replacing
a drive that is assigned to a partition, the new drive must be the same
technology and generation as the one you replace.

Add a Drive to the Library

Adding drives to an existing partition can cause the library to reassign element
Important
addresses. To avoid errors, make sure that when you install a new drive, you
reconfigure the element addresses your storage management software uses to
access the drives (refer to your software documentation for instructions).
If your library has unused drive bays, you can purchase additional drives
from Spectra Logic and add them to the library.
1. Log into the library as either a superuser or administrator.
2. Select Configuration > DLM (or Drives) to view a list of all the drives
3. Click Add next to a drive location that does not have a drive installed.
4.
5. If the drive has a Fibre Channel interface, connect it to an arbitrated
August 2019
D
EPLACING A
currently installed in the library.
Figure 256 The Drives screen.
Follow the Spectra T200, T380, T680, T950, and TFinity Drive Installation
or Replacement procedure to install the drive.
loop or fabric where the hosts reside.
RIVE
User Guide—Spectra T950V Library
Adding or Replacing a Drive
445