Configure And Test - Spectra Logic T-Series Spectra T200 User Manual

Configure and Test

1. Configure user profiles (user name, password, and user group), the
2. Configure one or more library partitions to meet your requirements.
3. Import all prepared TeraPack magazines and RXT media packs (if
4. Connect the library to the hosts in your operating environment. If using
5. Use the library diagnostics to move media to and from all locations in
6. Use backup software or other application software to perform a read/
7. Verify that the Remote Library Controller (RLC) can access the library
December 2008
library IP address, the BlueScale Vision camera IP address, email
notification profiles, and AutoSupport.
See Chapter 8 – Configuring the Library
change any of these settings.
The library must have a minimum of one partition configured.
See Chapter 7 – Using Partitions
modify existing partitions.
used).
Chapter 4 – Operating the Library
importing and exporting all types of media.
partitions, ensure that the transporter and appropriate drives are
accessible to each host.
See Chapter 7 – Using Partitions
the library, including the drives.
write test to each drive. See your software documentation for
information about reading and writing data.
user interface through a standard web browser.
See Understanding the User Interface on page 66
accessing the library from a remote location.
if you need to update or
if you want to add new partitions or
provides detailed information about
for information about setting visibility.
for information about
T200, T380, and T680 Libraries
Installation Steps
59