Configure And Test - Spectra Logic T-Series Spectra T200 Supplementary Manual

Chapter 3 — Installation Preparation
6. Install the license keys for all of the options you purchased, including
7. Update the library and drive firmware to the most current versions, if
8. Use the library diagnostics to test the operation of the transporter.

Configure and Test

Refer to the Spectra T200, T380, and T680 User Guide for this information.
1. Configure user profiles (user name, password, and user group), the
2. Configure one or more library partitions to meet your requirements.
3. Import all prepared TeraPack magazines and RXT media packs, if used.
4. Connect the library to the hosts in your operating environment. If using
5. Use the library diagnostics to move media to and from all locations in
6. Use backup software or other application software to perform a read/
7. Verify that the Remote Library Controller (RLC) can access the library
34
Site Prep Guide
capacity.
If you purchase additional options, refer to the user guide to learn how
to enter license keys and enable the options for use.
necessary.
If you need to update the library or drive firmware after your library is
installed, refer to the user guide for instructions.
library IP address, email notification profiles, and AutoSupport.
Read the chapter titled
or change any of these settings.
The library must have a minimum of one partition configured.
Read the chapter titled
partitions or modify existing partitions.
Read the chapter titled
information about importing and exporting all types of media.
partitions, ensure that the transporter and appropriate drives are
accessible to each host.
Read the chapter titled
visibility.
the library, including the drives.
Read the chapter titled
information about handling media in the library.
write test to each drive.
Refer to your software documentation for information about reading
and writing data.
user interface through a standard web browser.
Read the chapter titled
accessing the library from a remote location.
"Configuring the Library" if you need to update
"Using Partitions" if you want to add new
"Operating the Library" for detailed
"Using Partitions" for information about setting
"Importing, Exporting, and Moving
"Operating the Library" for information about
Media" for
91010004