Run The Dlm Drive Health Verification Wizard - Spectra Logic Spectra T950V User Manual

Tape library

Hide thumbs Also See for Spectra T950V:

Table of Contents

Chapter 13 — Drive Troubleshooting

Run the DLM Drive Health Verification Wizard

Use the following steps to launch the DLM Drive Health Verification wizard.

1. Log into the library as a user with superuser or administrative privileges.

2. If necessary, import a scratch tape and a cleaning cartridge into the

3. From the toolbar menu, select Configuration > DLM to display the

4. Click Test next to the drive you want to test to start the DLM Drive

library (see Requirements for Using the Wizard on page 382).

Drives screen.

The Test button is not present if DLM is not enabled.

Figure 207 Click Test on the Drives screen to launch the

Health Verification wizard.

The wizard determines whether all of the requirements for the test are

All Requirements Met If all of the requirements for performing the test

are met, the Drive Health Verification screen displays a warning about

the upcoming test process. Proceed to Step 5 on page 385.

Figure 208 Click Next on the Drive Health Verification screen

to begin the verification process.

Using DLM to Test a Drive

User Guide—Spectra T950V Library