Ts11Xx Technology Tape Drive Specifications - Spectra Logic Spectra T950V User Manual

Appendix C — Specifications
a. Assuming a 2.5:1 compression ratio. Compression throughput depends on the type of data.
b. This is a per-drive value. Total sustained transfer rate for the library depends on the number of drives
c. A 1.5 Gb interface speed does not stream an LTO-7 drive at 300 MB/second.
LTO-6 Drive
When connecting to a Fibre Channel network, LTO‐6 Fibre Channel drives
attempt to connect at 8 Gb/second, but auto‐negotiate down to 
4 Gb/second, 2 Gb/second, or 1 Gb/second, depending on the requirements
of the port to which the drive is connected.
a. Assuming a 2.5:1 compression ratio. Compression throughput depends on the type of data.
b. This is a per-drive value. Total sustained transfer rate for the library depends on the number of drives

TS11xx Technology Tape Drive Specifications

This section provides specifications for the TS11xx technology drives.
August 2019
Parameter
WORM capability
MTBF
Uncorrected error rate, calculated
Power consumption
installed in the library.
Parameter
Maximum sustained transfer rate
Speed matching range
Average space record time
Encryption capability
WORM capability
MTBF
Uncorrected error rate
Power consumption
installed in the library.
The specifications in this section are provided for convenience
Note:
only. Refer to the tape drive documentation for the most current
specifications (see TS11xx Technology Drives on page 20).
Tape Drive and Media Specifications
Specification
Yes
250,000 hours at 100% duty cycle
–19
1 x 10 bits
 Full‐height:
Read/write: 31 W Idle: 20 W
 Half‐height:
Read/write: 36 W Idle: 20 W
Specification
a, b
160 MB/second, native 
400 MB/second, compressed
40 MB/second to 160 MB/second
77 seconds
AES 256‐bit
Yes
250,000 hours at 100% duty cycle
–17
1 x 10 bits
Read/write: 28 watts typical
Idle: 8 watts
User Guide—Spectra T950V Library
490