Spectra Logic Spectra T950V User Manual page 346

Chapter 12 — Library Troubleshooting
7. Use the Select a configuration time stamp drop‐down list to select the
8. Click Run Utility.
Before the library is restored using the configuration backup file on a USB device,
Important
the library's current configuration is saved to the USB device with a time stamp
indicating when the file was created. The library is then restored using the selected
configuration backup file on the USB device.
The USB device now contains one additional Auto Configuration Save file.
9. Once the library begins its power‐on sequence, remove the USB device
If you do not remove the USB device, the library power-on sequence fails. 
Important
If the library fails to boot, power off the library as described in
on page
the library as described in
Restore Other Configuration Changes
The library does not immediately generate a configuration backup file
when you make changes to any of the library configuration settings other
than those for partitions. If you made any changes to the library
configuration after the automatically generated configuration backup file
you used to restore the library was generated, you need to repeat those
changes after completing the restore.
 If you have a manual backup of the library configuration that is more
 If you do not have a manual backup available, you need to restore the
August 2019
configuration backup file you want to use. The automatically generated
configuration backup files are named <date-time>cfg.zip, where
is the time stamp for when the file was created.
<date-time>
Unless you replace the LCM or its memory card, the first file listed is
the zipped configuration backup file stored on the LCM memory card.
Note: If available, the zipped configuration backup file stored on the LCM
memory card usually contains the most recently saved library
configuration information, as well as the MLM and DLM databases.
Check the time stamp in the filename to determine whether any
manually generated backup file you have is more recent.
After a brief delay, the Utility Results screen appears, showing that the
configuration was restored. The library then performs a power‐ cycle
reset.
if necessary.
144. Once the library is powered off, remove the USB device and power on
Power On the Library on page
current than the automatically generated configuration backup file you
used, you can use it to restore the updated configuration (see Restore
the Library Configuration Using a Saved Configuration on page 348).
following changes manually:
Restoring the Library Configuration
Power Off the Library
142.
User Guide—Spectra T950V Library
346