Honda Accord 2008 Manual page 2492

07/11/02 09:48:33 61TA0000_230_0048
3. By pressing a preset button, the input will trigger the diagnostic mode that is assigned to that preset switch.
No. 2 button
Audio button, knob, and remote switch detection: Allows individual manual selection of all audio panel knobs,
buttons, and remote switches to verify if they are functional. When properly detected, the applied knob button, or
remote switch name and/or value will be displayed. To exit this mode, go to step 4.
No. 3 button
Entire LCD lighting/light-out mode: Turns on/off the entire LCD to show the presence or absence of an LCD failure.
No. 4 button
Illumination level indication mode: Indicates the duty cycle for the illumination dimmer control of the gauge
assembly.
Gauge dimmer control values:
Headlights off: OFF
Headlights on: 01 (max low) through 22 (max high)
No. 5 button
Vehicle speed pulse indication mode: Indicates the Vehicle speed pulse.
AM/FM or FM button (Push and hold 5 sec.)
Reception level check mode: Indicates the reception level. When entering the reception level check mode, the AM/
FM button or FM button is used to change the main/sub antenna.
How to Obtain the Audio Unit Serial Number
NOTE: This procedure can only be done when the power has been disconnected from the audio unit, displays CODE.
With the audio unit switched off, push and hold the preset button No. 1, No. 6 and the VOL PUSH PWR knob, then
release. The audio unit displays the eight digit serial number (example 12345678). Use the eight digit serial number
when using the interactive network (iN) to get the 5 digit anti-theft codes.
Serial Number
＊０２
With navigation Without navigation (Premium, 6 CD, 1 CD)
(cont'd)
23-47