Honda Accord 2008 Manual page 2506

07/11/02 09:49:43 61TA0000_230_0062
21. Check for continuity between the audio unit
connector F (3P) No. 1 and No. 2 terminals.
＊０９
Is there continuity?
YES
sublead.
NO −
the reception still poor, replace the audio unit.
• With navigation system (see page 23-109)
• Without navigation system (see page 23-111)
AUDIO UNIT CONNECTOR F (3P)
RF SH
RF IN
Terminal side of female terminals
− Replace the AM/FM antenna lead and/or
Replace the AM/FM antenna and recheck. If
Audio unit power switch will not turn on (No
information display and no sound)
NOTE:
• Check the vehicle battery condition first.
• Check the connectors for poor connections or loose
terminals.
1. Turn the ignition switch to ON (II).
2. Push the power switch ON to see if audio unit turns
ON.
Does the audio unit display operate properly, and
dose the audio unit sound normal?
YES − Intermittent failure, the system is OK at this
time.
NO − Go to step 3.
3. Turn the ignition switch to LOCK (0).
4. Check the No. 15 (10 A) fuse in the under-hood
fuse/relay box and the No. 18 (7.5 A) fuse in the
driver's under-dash fuse/relay box.
Are the f uses OK ?
YES − Go to step 5.
NO − Replace the fuse, and recheck.
5. Remove the audio unit with navigation system
(see page 23-109), without navigation system
(see page 23-111). Check that the audio unit
connectors are properly connected.
Are they connected properly?
YES − Go to step 6.
NO − Repair poor connections and reconnect the
connectors, and recheck the function.
6. Disconnect audio unit connector A (24P).
NOTE: Eject all the CDs before disconnecting the
audio unit and CD changer to prevent damaging
the CD player's load mechanism.
7. Turn the ignition switch to ON (II).
ＴＡ０８Ａ００Ｊ１０３００００００００ＦＡＡＴ０３
(cont'd)
23-61 23-61