07/11/02 09:49:44 61TA0000_230_0064
No sound is heard from the speaker(s)
(display is normal) (with premium audio)
NOTE:
• Check the vehicle battery condition first.
• Check the connectors for poor connections or loose
terminals.
• Set the fader and balance positions to the center.
• Before doing the troubleshooting, do the Audio unit
power switch will not turn on troubleshooting
(see page 23-61).
1. Turn the ignition switch to ON (II).
2. Turn on the audio unit and make sure the volume
button is not set to the MIN level.
Is it at the MIN level?
YES
−
Raise the volume level, and recheck the
function.
NO
−
Go to step 3.
3. On the steering wheel, check the navigation talk
command, and/or the HandsFreeLink talk
command function.
Are the navigation talk command and/ or the HF L
talk command f unction set?
YES
−
Cancel the navigation talk command by
pressing the navigation BACK button, and/or HFL
talk command, press the HFL BACK button, then
recheck the function.
NO
−
Go to step 4.
4. Do the speaker check mode with the self-diagnostic
function (see page 23-50).
Do all speakers produce a tone?
YES
−
System is OK at this time. Check for poor
connections at the audio unit, speakers and stereo
amplifier.
−
NO
Go to step 5.
5. Turn the ignition switch to LOCK (0).
6. Check the speaker(s) with on sound for any
damage.
Is there any damage?
YES
−
Replace the speaker and recheck.
−
NO
Go to step 7.
7. Remove the speaker(s) with no sound (see page
23-118), and disconnect its connector.
8. Check the speaker 2P connector for a loose or poor
connection.
Reconnect the speaker connector, and recheck the
symptom; is the condition still present?
YES
−
Go to step 9.
−
NO
Intermittent failure. Operation is normal.
TA08ANRJ10300000000FAAT05
(cont'd)
23-63