Subaru Legacy 2004 Service Manual page 3991

6. Rear Door
A: REMOVAL
1. REAR DOOR PANEL
1) Disconnect the ground cable from battery.
2) Remove the rear door trim. <Ref. to EI-48, RE-
MOVAL, Door Trim.>
3) Remove the rear speaker. <Ref. to ET-9, RE-
MOVAL, Rear Speaker.>
4) Pull back the sealing cover. <Ref. to EB-24, RE-
MOVAL, Rear Sealing Cover.>
5) Remove the rear door glass. <Ref. to GW-22,
REMOVAL, Rear Door Glass.>
6) Remove the door sash and rear door regulator
and motor assembly. <Ref. to GW-24, REMOVAL,
Rear Regulator and Motor Assembly.>
7) Remove the rear door latch. <Ref. to SL-34, RE-
MOVAL, Rear Door Latch and Door Lock Actuator
Assembly.>
8) Remove the rear outer handle. <Ref. to SL-33,
REMOVAL, Rear Outer Handle.>
9) Remove the screw to remove the door trim
bracket.
Rear Door
10) Remove the rear door inner weather strip.
NOTE:
If the weather strip clip is removed with excessive
force, the weather strip may be damaged. Be sure
to use clip remover to remove.
11) Remove the bolts and nuts to remove the door
checker.
12) Remove the rear door. <Ref. to EB-21, REAR
DOOR ASSEMBLY, REMOVAL, Rear Door.>
EB-00152
2. REAR DOOR ASSEMBLY
1) Disconnect the ground cable from battery.
2) Remove the center pillar lower trim. <Ref. to EI-
60, REMOVAL, Lower Inner Trim.>
EB-21
EXTERIOR BODY PANELS
(A)
(B)
(A) Pin clip
(B) Weather strip clip
(A)
EB-00156
EB-00141
EB-00154