Subaru Legacy 2004 Service Manual page 2935

DRIVE SHAFT SYSTEM
NOTE:
If it is hard to remove, use STs.
ST1 926470000 AXLE SHAFT PULLER
ST2 927140000 AXLE SHAFT PULLER
PLATE
ST1
B: INSTALLATION
1) Aligning the hub unit bearing to the mounting
hole of the back plate, install the hub unit assembly
and back plate. Tighten the axle nut temporarily.
CAUTION:
• Be careful not to damage the magnetic en-
coder.
• Do not get closer the tool which charged
magnetism to magnetic encorder.
(1) Magnetic encoder
(2) Rear hub unit bearing
Rear Hub Unit Bearing
ST2
DS-00122
(2)
(1)
DS-00251
DS-00151
DS-20
2) Tighten the four bolts to the back plate.
Tightening torque:
"
65 N m (6.6 kgf-m, 47.9 ft-lb)
3) Remove the axle nut.
4) Draw the rear drive shaft into specified position.
5) Tighten the new axle nut temporarily.
CAUTION:
Use a new axle nut (olive color).
6) Install the disc rotor on hub.
7) Install the disc brake caliper on back plate.
Tightening torque:
"
52 N m (5.3 kgf-m, 38.3 ft-lb)
8) Install the rear ABS wheel speed sensor and
brake cable bracket.
9) Adjust the parking brake lever stroke by turning
adjuster. <Ref. to PB-5, ADJUSTMENT, Parking
Brake Lever.>
DS-00149
DS-00152
DS-00147