Subaru Legacy 2004 Service Manual page 2961

5. Rear ABS Wheel Speed Sen-
sor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the connector from rear ABS wheel
speed sensor.
3) Remove the sensor harness bracket from rear
arm.
4) Remove the rear ABS wheel speed sensor from
rear arm.
Rear ABS Wheel Speed Sensor
ABS00389
ABS00166
ABS00167
ABS00168
ABS-15
CAUTION:
• Be careful not to damage the sensor portion.
• Do not apply excessive force to the sensor
harness.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
Be careful not to damage the sensor portion.
Tightening torque:
Sensor:
"
7.5 N m (0.76 kgf-m, 5.5 ft-lb)
Bracket:
"
33 N m (3.3 kgf-m, 24 ft-lb)
NOTE:
Check the identification (mark) on the harness to
make sure that no warp exists. (RH:K5(White),
LH:K6(Yellow))
C: INSPECTION
1. ABS WHEEL SPEED SENSOR
<Ref. to ABS-13, ABS WHEEL SPEED SENSOR,
INSPECTION, Front ABS Wheel Speed Sensor.>
ABS
ABS00390