Subaru Legacy 2004 Service Manual page 2922

C: CAUTION
• Wear work clothing, including a cap, protective
goggles, and protective shoes during operation.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Be careful not to burn yourself, because each
part on the vehicle is hot after running.
D: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
ST-922431000
(A)
ST-925091000
ST-926470000
General Description
TOOL NUMBER
922431000
925091000
(B)
926470000
• Use SUBARU genuine grease etc. or the equiv-
alent. Do not mix grease, etc. with that of another
grade or from other manufacturers.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Apply grease onto sliding or revolution surfaces
before installation.
• Before installing snap rings, apply sufficient
amount of grease to avoid damage and deforma-
tion.
• Before securing a part on a vise, place cushion-
ing material such as wood blocks, aluminum plate,
or shop cloth between the part and the vise.
DESCRIPTION
AXLE SHAFT • Used for installing axle shaft into housing.
INSTALLER • Used with ADAPTER (927390000).
BAND TIGHTENING Used for tightening boot band.
TOOL (A) Jig for band
(B) Ratchet wrench
AXLE SHAFT Used for removing axle shaft.
PULLER
DS-7
DRIVE SHAFT SYSTEM
REMARKS