Subaru Legacy 2004 Service Manual page 2938

C: DISASSEMBLY
1) Place alignment marks on the shaft and outer
race.
2) Remove the PTJ boot band and boot.
CAUTION:
Be careful not to damage boot.
3) Remove the snap ring from PTJ outer race.
4) Remove the PTJ outer race from shaft assem-
bly.
5) Wipe off grease.
CAUTION:
The grease is a special grease. Do not confuse
with other greases.
Front Drive Shaft
6) Place alignment marks on the roller kit and trun-
nion.
DS-00106
7) Remove the roller kit from trunnion.
CAUTION:
Be careful with the roller kit position.
DS-00107
8) Place alignment marks on the trunnion and
shaft.
DS-00108
9) Remove the snap ring and trunnion.
CAUTION:
Be sure to wrap shaft splines with vinyl tape to
prevent boot from scratches.
DS-23
DRIVE SHAFT SYSTEM
DS-00109
DS-00110
DS-00111