Subaru Legacy 2004 Service Manual page 2950

ABS
2. ABS CONTROL MODULE AND HYDRAULIC CONTROL UNIT (ABSCM&H/U)
(1) ABS control module and hydraulic
control unit (ABSCM&H/U)
(2) Front outlet RH
(3) Rear outlet LH
(4) Rear outlet RH
(5) Front outlet LH
C: CAUTION
• Wear work clothing, including a cap, protective
goggles and protective shoes during operation.
• Before disconnecting electrical connectors of
sensors or units, be sure to disconnect the ground
cable from battery.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Be careful not to burn yourself, because each
part on the vehicle is hot after running.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
General Description
(6)
T2
(11)
T2
(6) Primary inlet
(7) Secondary inlet
(8) Damper
(9) Spacer
(10) Damper
(5)
(4)
(3)
(2)
(8)
(10)
ABS-4
(7)
(1)
(9)
T1
T2
(11) Bracket
"
Tightening torque: N m (kgf-m, ft-lb)
T1: 7.5 (0.76, 5.5)
T2: 33 (3.3, 24)
ABS00381