Subaru Legacy 2004 Service Manual page 2955

ABS Control Module and Hydraulic Control Unit (ABSCM&H/U)
NOTE:
Before securing a part on a vice, place cushioning
material such as wood blocks, aluminum plate or
cloth between the part and vice.
(1) Aluminum plate or etc.
(2) Vise
®
4) Using TORX bit T20, remove the four screws of
ABSCM.
NOTE:
Always use new screws.
5) Slowly remove the ABSCM upward from H/U.
NOTE:
To prevent damaging of coil part, remove the AB-
SCM straightly from H/U.
6) Ensure there are no dirt or damage on sealing
surface of H/U.
CAUTION:
• Do not clean the ABSCM & H/U with applying
compressed air.
• Do not repair the damages of H/U sealing sur-
face using file or metal scraper. To remove the
sealing, use resin scraper. Do not use the
chemical materials (thinner and etc.).
7) Position the coil of new ABSCM to align H/U
valve.
8) To prevent deforming of ABSCM housing cover,
hold the corner of ABSCM and install it to the H/U
without tilting.
®
9) Using TORX bit T20, tighten the screws step-
wise in the order of (1) through (4).
CAUTION:
Always use new screws.
Tightening torque:
1.5 N
(1)
(2)
ABS00430
10) Check that there is no foreign matter in aligning
part between ABSCM and H/U.
11) Using TORX
wise in the order of (1) through (4) again.
Tightening torque:
3 N
12) Check that there is no clearance in aligning part
between ABSCM and H/U.
13) Install the ABSCM&H/U to vehicle.
ABS00431
ABS-9
"
m (0.15 kgf-m, 1.1 ft-lb)
(1) (3)
(4)
®
bit T20, tighten the screws step-
"
m (0.3 kgf-m, 2.2 ft-lb)
ABS
(2)
ABS00432