Subaru Legacy 2004 Service Manual page 2942

6) Lock the axle nut securely.
7) Install the wheel.
Tightening torque:
"
90 N m (9.2 kgf-m, 66 ft-lb)
C: DISASSEMBLY
1) Straighten the bent claw of larger end of DOJ
boot.
2) Loosen the band by means of screwdriver or pli-
ers.
CAUTION:
Be careful not to damage boot.
3) Remove the boot band on the small end of DOJ
boot in the same manner.
4) Remove the larger end of DOJ boot from DOJ
outer race.
5) Pry and remove the round circlip located at the
neck of DOJ outer race with a screwdriver.
6) Take out the DOJ outer race from shaft assem-
bly.
Rear Drive Shaft
7) Wipe off the grease and take out balls.
CAUTION:
The grease is a special grease (grease for con-
stant velocity joint). Do not confuse with other
greases.
NOTE:
Disassemble exercising care not to lose balls (6
pcs).
DS-00048
8) To remove the cage from inner race, turn the
cage by a half pitch to the track groove of inner race
and shift the cage.
9) Remove the snap ring, which fixes inner race to
shaft, using pliers.
10) Take out the DOJ inner race.
11) Take off the DOJ cage from shaft and remove
DOJ boot.
CAUTION:
Be sure to wrap shaft splines with vinyl tape to
prevent boot from scratches.
DS-00124
12) Remove the BJ boot or EBJ boot in the same
procedure as DOJ boot.
NOTE:
Further disassembly of axle is impossible because
the BJ and EBJ cannot be disassembled.
D: ASSEMBLY
NOTE:
Use specified grease.
BJ side:
NTG2218-M (Part No. 28395AG010)
EBJ side:
NTG2218-M (Part No. 28395AG000)
DOJ side:
NKG205 (Part No. 28495AG000)
DS-00125
1) Install the BJ or EBJ boot in specified position,
and fill it with 60 to 70 g (2.12 to 2.47 oz.) of speci-
fied grease.
DS-27
DRIVE SHAFT SYSTEM
(A)
(A) Outer race
(B) Grease
(B)
DS-00126