Operation Settings; To Set The Pix/Wf Operations; Setting The Battery Alarm - Sony MSU-1000 Operation Manual

Operation Settings

To set the PIX/WF operations

You can set the following operations for PIX/WF output.
• Whether to link output from the PIX2 OUTPUT and WF2
OUTPUT connectors to RGB switching on the adjustment
display (PIX/WF Synchro setting).
• Turn ON/OFF All Mode (PIX/WF/Synchro setting)
• Control mode of the monitor selection buttons (PIX/WF
Control Mode setting)
1
Enter engineer mode. (page 35)
2
Press the CONFIG button.
The menu closes and the control panel remains in
engineer mode.
3
Display the MSU Config screen. (page 35)
MSU Config
Display
Customize
/Sound
Security
4
[Mode]
Press .
The Mode screen appears.
MSU Mode
Screen
PIX/WF
Saver
Battery
Alarm
5
[PIX/WF]
Press .
The PIX/WF screen appears.
PIX/WF
PIX/WF Synchro
ON
6
Set the PIX/WF operations.
The following settings can be configured.
30
Settings
Engineer Mode Exit
Mode Date/Time Network Information
Backup
Engineer Mode Exit
Matrix Extend Camera
Gate CALL Select
Engineer Mode Exit
PIX/WF All Mode PIX/WF Control Mode
Alter-
ON Direct
nate
PIX/WF Synchro
Turn ON/OFF linking of output from the PIX2 OUTPUT
and WF2 OUTPUT connectors to RGB switching on the
adjustment display.
[ON]
• Press to light the button and switch to linking of
output from the PIX2 OUTPUT and WF2 OUTPUT
connectors to RGB switching on the adjustment display
when the white shading or black shading is adjusted.
[OFF]
• Set to output the signal selected with the
PICTURE MONITOR or WAVEFORM MONITOR
buttons from the PIX2 OUTPUT and WF2 OUTPUT
connectors regardless of the RGB selection in the
adjustment screen.
PIX/WF All Mode
Turn ON/OFF PIX/WF All mode.
[ON]
• Press to light the button and set each of the buttons
of PICTURE MONITOR or WAVEFORM MONITOR to
function for all of the cameras in the selected group.
[OFF]
• Set to set each of the buttons of PICTURE
MONITOR or WAVEFORM MONITOR to function for only
the camera selected with a camera selection button.
PIX/WF Control Mode
Select the control mode of the monitor selection buttons.
[Direct]
• Press to switch to direct mode. When you press
any of the R, G, and B buttons of the PICTURE
MONITOR and WAVEFORM MONITOR to light it, the
button that was pressed previously goes out, and the
signal corresponding to the newly pressed button is
output. To output the R and G signals, press the G
button while holding down the R button.
[Alternate]
• Press to switch to alternate mode. When you
press any of the R, G, and B buttons of the PICTURE
MONITOR and WAVEFORM MONITOR to light it, the
signal is output in combination with that of the button that
is already lit. To output the R and G signals, press the R
button to light it and then press the G button to light it.
When the B button is lit, press it so that it goes out.

Setting the Battery Alarm

The battery alarm is displayed on the LCD when the control
panel operates on DC power. Before End and End voltages for
the battery alarm can be set.
1
Enter engineer mode. (page 35)
2
Press the CONFIG button.
The menu closes and the control panel remains in
engineer mode.
3
Display the MSU Config screen. (page 35)
MSU Config
Display
Customize Mode
/Sound
Security
Engineer Mode Exit
Date/Time Network Information
Backup