Powering On And Off; Checking The Power And Voltage - Sony SRPC-1 Operation Manual

Note
If you are attaching an AC adaptor to the battery
attachment section, set BATTERY >BATT TYPE in the
SYSTEM Setup menu to "AC Adapter" (see page 60). If
you are connecting an AC adaptor to the DC IN connector,
set BATTERY >DC IN TYPE in the SYSTEM Setup
menu to "AC Adapter".

3-4-3 Powering On and Off

To power on
To power the SRW-1 and SRPC-1 on, proceed as follows.
1
If you are using an AC adaptor, turn the AC adaptor
on.
2
Turn the SRPC-1 POWER ON/OFF switch to ON.
The SRW-1 is powered on automatically when its
POWER ON/OFF switch is set to ON.
Powering on when the optional HKSR-101 is
installed
If you have installed the optional HKSR-101 in SRPC-1 to
connect this unit to a HDC-F950 camera via optical-fiber
cable, power on in the order this unit on t HDC-F950 on.
Signal transmission may not be conducted properly if this
power-on order is not observed.
To power off
Note
To protect tapes, do not power the SRW-1 off with a
cassette loaded. Always eject the cassette first, and then
use the following procedure to power the system off.
1
Turn the SRPC-1 POWER ON/OFF switch to OFF.
If the SRW-1 POWER ON/OFF switch is set to ON,
the SRW-1 is also powered off automatically.
2
If you are using an AC adaptor, turn the AC adaptor
off.
If you should ever power off with a cassette still loaded in
the SRW-1, the unit does not power off immediately. To
protect the tape, the unit powers off after first returning the
tape to the unthread position.
36
3-4 Power Supply Preparations
3-4-4 Checking the Power and
Voltage
To check the type of power being used
A battery mark appears in the lower left of the control
panel display when power is being supplied from the
battery attachment section.
A power plug mark appears when an AC adaptor is
selected as power supply.
12.2V
Note that this mark does not reflect the actual type of
power being used, but reflects the settings of the following
menu items.
• SYSTEM Setup >BATTERY >BATT TYPE
• SYSTEM Setup >BATTERY >DCIN TYPE
To check the remaining battery power
You can check the remaining battery power with the
battery level display.
12.2V
As the battery pack discharges, the segments go out from
left to right. When the battery pack is almost exhausted
(NEAR END), the voltage indication and the tally
indicator start to flash, and an intermittent warning tone
sounds in the headphones. When the battery pack is
completely exhausted (END), the corresponding warning
indication lights, the tally indicator starts to flash at a
higher rate, and the headphones warning tone sounds
continuously.
The BATTERY item in the SYSTEM Setup menu (see
page 60) allows you to set the battery voltages for which
NEAR END and END warnings are issued.