Servo Drive Specifications - Omron R88D-KN01L-ECT-L User Manual

3 Specifications
3-1

Servo Drive Specifications

Select a Servo Drive that matches the Linear Motor to be used.
3-1-1 General Specifications
Item
Operating ambient
temperature and humidity
Storage ambient
temperature and humidity
Operating and storage
atmosphere
Vibration resistance
Insulation resistance
Dielectric strength
Protective structure
Note 1 The above items reflect individual evaluation testing. The results may differ under compound conditions.
2 Disconnect all connections to the Servo Drive before attempting a megameter test (insulation resistance
measurement) on a Servo Drive. Failure to follow this guideline may result in damaging the Servo Drive.
3 Never perform dielectric strength or other megameter tests on the Servo Drive. Failure to follow this guideline may
result in damaging the internal elements.
4 Some Servo Drive parts will require maintenance. For details, refer to 12-5 Periodic Maintenance on page 12-35.
5 Following may be caused by incoming electrical noise (unstable, vibration, accoustic noise, etc.). In such case, refer
to 4-4 Noise Reduction on page 4-29 for measure to reduce noise.
International standard
*1 EMC Directive
EC Directives
Low Voltage
Directive
Machinery
Directives
UL standards
CSA standards
Korean Radio Regulations (KC)
*1 This Servo Drive is third-party certified in combination with rotary motor models. It is the user's responsibility to perform
final checks on the compliance of the entire system.
3 - 2
0 to 55°C, 20% to 85% max. (with no condensation)
–20 to 65°C, 20% to 85% max. (with no condensation)
No corrosive gases
10 to 60 Hz and at an acceleration of 5.88 m/s
resonance point)
Between power supply terminals/power terminals and FG terminal: 0.5 MΩ min. (at 500 VDC)
Between power supply/power terminals and FG terminal: 1,500 VAC for 1 min at 50/60 Hz
Built into panel
EN55011, EN61000-6-2, EN61800-3
EN 61800-5-1
EN954-1(Cat.3), EN ISO13849-1 (Cat.3)(PLc, d), ISO13849-1(Cat.3)(PLc, d),
EN61508(SIL2), EN62061(SIL2), EN61800-5-2 (STO), IEC61326-3-1 (SIL 2)
UL 508C
CSA C22.2 No.14
Compliant
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
Specifications
2
or less (Not to be run continuously at a